Bizarre,
Anyone notice that you cannot set breakpoints in AFL code after a file is read in via…
fh1 = fopen( InputFile, "r" ); because apparently it won't read-in a file when debugging?
Also some aggravating stuff like setting a break point and thinking that dragging an indicator to a chart would start execution of the code and hit the beak point. Doesn't work.
I haven't even tried to debug staticvarset and get.
Comments?
-S
__._,_.___
Posted by: "Sean ONeill" <ONeillSeanP@verizon.net>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (14) |
**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.
TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com
TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
This group is for the discussion between users only.
This is *NOT* technical support channel.
TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com
TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
.
__,_._,___
EmoticonEmoticon