[amibroker] Re: Explore & Debug vs. Code Check: What's Different?

 

Hello,

I use Code Check and Profile very often and have noticed, that it behaves strange in some situations.

Usually Code Check and Profile shows precise and detailed information, but in some formulas it shows almost nothing. In one of my codes which contains many StaticVarGet() (used without any condition) it doesn't show (and measure) any of them. That is strange... But in another formula Code Check and Profile shows that StaticVarGet was used (for example) 50 times, whereas I have checked that is used only a couple of times. I don't understand what is the reason...

Regards

Miłosz 

__._,_.___

Posted by: milosz.mazurkiewicz@yahoo.com
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (4)
**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.

TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com

TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/


.

__,_._,___


EmoticonEmoticon