Hello,
There is no "misleading information" given by code check and profile.
What you have observed is due to the fact that there is NO "Parameter" window
in the EDITOR.
You are changing parameters somewhere else (in chart or in analysis).
Parameters work CONTEXTUALLY so they are applied ONLY in the context
where Parameter window was used. Specifically parameters are tied to Chart ID.
Editor does not care if you use the same formula in one or more charts.
So if you have parameter set for given CHART, it applies to THAT chart and nowhere else.
Setting parameter in chart does not affect other charts or analysis window or editor.
This is done so to allow INDEPENDENT control of parameters for each chart.
Editor always uses default parameter values as specified in the code.
See Knowledge Base
http://www.amibroker.com/kb/2014/10/06/relationship-between-chart-panes/
http://www.amibroker.com/kb/2015/01/28/why-analysis-results-and-chart-output-may-differ/
http://www.amibroker.com/kb/2014/10/29/using-per-symbol-parameter-values-in-charts/
Best regards,
Tomasz Janeczko
amibroker.com
I have noticed (and checked), that in some situations, Code Check & Profile might give misleading information (the second post):
http://amibrokerforum.proboards.com/thread/128/performance-tuning-tips
Regards
Miłosz
Posted by: Tomasz Janeczko <groups@amibroker.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (11) |
This group is for the discussion between users only.
This is *NOT* technical support channel.
TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com
TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
EmoticonEmoticon